I didn't have a place to put my Bluetooth headset, so I thought I'd build in the headset charging cable to the controller charging station it's nice to have all things in one place.
1. tools needed
file, glue, knife, drill, cutting pliers and a screwdriver
2. open,
start with opening up the case.
3. Make the cable hole
use the drill and knife to get a half-circle hole that the headset charging cable fits in
4. make the other cable hole
remove the shiny plastic thing and start to drill and cut until the end of the cable fits precisely in
the hole.
5. Glue
make sure the cables is in the right position then glue it from below.
6. Shiny thing
cut the shiny thing so that it fits around the end of the cable.
7. Done!
now you have an all in one charging station!
Posts
No comments:
Post a Comment